Clay-paky MYTHOS User Manual download pdf (Page 14)

MYTHOS

Switching on the projector - Fig. 8

Press the switch. The projector starts resetting the effects. At the same time, the following information scrolls on the display:

Model Firmware xxx (Fixture ID) System errors

MYTHOS Version X.X.X Dmx Address xxx E: .........................

Date - Hour W: .........................

On conclusion of resetting in case of absence of the dmx signal, Pan and Tilt move to the “Home” position (Pan 50% - Tilt 50%). The control panel

(Fig. 8) has a display and buttons for the complete programming and management of the projector menu. The display can be in one of two

conditions: rest status and setting status. When it is in the rest status, the display shows the projector’s DMX address and the Fixture ID address

(if set).

During menu setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns to rest status.

It should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the

key will be cancelled.

CONTROL PANEL

Dmx Address

Warning Message

Fixture ID

18m

Connecting to the control signal line (DMX) - Fig. 7

Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity. Do not use

microphone cable or other cable with characteristics differing from those specified. The end connections must be made using XLR type 5-pin male/female