Clay-paky POINT / POINT IN User Manual download pdf

A. Microswitches from 1 to 11:

For DMX address setting and programming.

B. Microswitch 12:

To select operating mode:

The ON setting enables SLAVE mode.

The OFF setting enables MASTER mode.

C. Led "DMX" (green):

When on, it indicates that a DMX input signal

is present and that the starting address is

valid.

When flashing, it indicates that no DMX input

signal is present or that the starting address is

not valid.

D. Led "OUT" (yellow):

When on, it indicates that the projector is in

Master mode and can control other projectors.

E. "DMX" address:

This is the sum of values corresponding to the

microswitches set to ON.

12V 50W

POINT / POINT IN

The projector may be programmed to operate in AUTOMATIC mode (it carries out previously set scenes or sequences), or controlled by a CONTROL UNIT.

ABCD

123456789101112

128

256

OUT

DMX

AUTOMATIC MODE

In automatic, the projector may be configured in two different modes: SLAVE and

MASTER

1) SLAVE Mode: (microswitch 12 set to ON) The projector receives a DMX signal and

carries out the sequences transmitted from a main projector configured in

MASTER

mode.

The projectors should have address

1 (see programming automatic SLAVE mode).

OPERATION WITH CONTROL UNIT (DMX mode)

All the projectors must be configured in SLAVE mode (Microswitch 12 set to ON); the

projector receives a DMX signal and carries out the controls transmitted from the

control unit.

MASTER Mode: (microswitch 12 set to OFF) The projector generates a DMX signal

that can pilot other projectors in

SLAVE mode.

In this case, there should be no DMX signal.

Address: 1

Mode: SLAVE

Max

100

Address: 1

Mode: SLAVE

Address: 1

Mode: SLAVE

Mode:

MASTER

DMX

Address: 1

Mode: SLAVE

Max

100

Address: 1

Mode: SLAVE

Address: 1

Mode: SLAVE

Mode:

MASTER

DMX

Address: 1

Mode: DMX

Address: 3

Mode: DMX

Address: 5

Mode: DMX

Control unit

DMX

On each projector, set the address for DMX digital signal: addresses are valid from 1 to

511 (see Programming operation with Control unit).

Each projector uses 2 control channels.

CHANNEL FUNCTION

COLOUR DISC

DIMMER

123456789101112

128

256

123456789101112

128

256

N.B.: To access the microswitches, remove the electronic card cover.

POINT

POINT IN

MICROSWITCHES

INSTRUCTIONS MANUAL

OPERATION

Channel functions and options

1 2

POINT / POINT IN 1
PROGRAMMING 2

Summary of Contents

Page 1 - POINT / POINT IN

A. Microswitches from 1 to 11:For DMX address setting and programming.B. Microswitch 12:To select operating mode:The ON setting enables SLAVE mode.The

Page 2 - PROGRAMMING

123456789101112ONSet microswitch 1 to ON.The address can also be set with the projectorswitched off.123456789101112ONChange microswitch 12 over to ON.