Clay-paky SHOW BATTEN 100 AS User Manual download pdf (Page 2)

SHOW BATTEN 100

• Installation

Make sure all parts for fixing the projector are in a good state of repair. Make sure the point of anchorage is stable

before positioning the projector.

The safety chain must be properly hooked onto the fitting and secured to the framework, so that, if the primary

support system fails, the fitting falls as little as possible.

If the safety chain gets used, it needs to be replaced with a genuine spare.

• Minimum distance of illuminated objects

The projector needs to be positioned so that the objects hit by the beam of light are at least 0.2 metres (8”) from the

lens of the projector.

• Minimum distance from flammable materials

The projector must be positioned so that any flammable materials are at least 0.20 metres (8") from every point on

the surface of the fitting.

• Maximum ambient temperature

Do not use the project if ambient temperature (Ta) exceeds 40°C.

• IP20 protection rating

The fitting is protected against penetration by solid bodies of over 12mm (0.47”) in diameter (first digit 2), but not

against dripping water, rain, splashes or jets of water (second digit 0).

• Protection against electrical shock

Connection must be made to a power supply system fitted with efficient earthing (Class I appliance according to

standard EN 60598-1). It is, moreover, recommended to protect the supply lines of the projectors from indirect

contact and/or shorting to earth by using appropriately sized residual current devices.

• Connection to the power mains

A qualified electrician must perform connection to the power mains.

Check that the mains frequency and voltage correspond to the frequency and voltage for which the projector was

designed and indicated on the electrical data label. This label also gives the input power. Refer to the latter to

evaluate the maximum number of devices to be connected to the mains to avoid overloads.

• External surface temperature

The maximum temperature that can be reached on the external surface of the fitting, in a thermally steady state, is

100°C (212°F).

• Maintenance

Before starting any maintenance work or cleaning the projector, cut off power from the supply mains. After switching

off, do not remove any parts of the fitting for at least 10 minutes. The lenses must be mounted and, if visibly

damaged, they have to be replaced with genuine spares.

• Photobiological Safety

CAUTION. Do not look directly at the light source.

Do not look at the light beam with optical devices or any other tool that could cause light convergence.

This product is intended for the following areas of application:

studios, stages, theaters, exhibitions, trade fairs, events, theme parks, entertainment venues, architectural lighting

and similar

Not suitable for household illumination

Not for residential use

AFETY INFORMATION SHOW BATTEN 100

0.2

IP20

Risk Group 1

According to

EN 62471

100°C

40°C

1 2 3 4 5 6 7 ... 31 32

Comments to this Manuals

No comments

Clay-paky SHOW BATTEN 100 AS User Manual Page 2

Comments to this Manuals

Related products and manuals for Projectors Clay-paky SHOW BATTEN 100 AS