Clay-paky A.LEDA B-EYE K20 (C61420) User Manual download pdf (Page 15)

A.LEDA B-EYE

NETWORK PARAMS

Allows the "Network" parameters of the projector to be displayed or:

IP address: Internet Protocol address (two projectors must not have the

same IP address)

P mask: 255.0.0.0

Mac address: Media Access Control: the projector’s Ethernet Address.

RESET

Used for resetting the projector.

1) Press

to reset the projectors, a confirmation message (Are you

sure ?) appears on the display.

2) Select YES to starting reset the fixture or NO to keep the current setting

and return to the top menu level.

CHANNEL

Used for setting channel levels from the projector control panel.

1) Press

- the first channel appears on the display.

2) Use the UP

and DOWN

keys to select the required channel:

3) Press

and use the UP

and DOWN

keys to select the

required DMX level (value between 0 and 255).

4) Press LEFT

to return to the top menu level.

TEST

Allows you to check the proper functioning of effects.

1) Press

to return to the top menu level.

2) Use the UP

and DOWN

keys to select the required test.

3) Press

to confirm the selection or LEFT

to keep current settings.

Test sequence:

Pan - Tilt effects (Pan & Tilt)

Colours

Zoom

Zoom rotation

All effects

Zoom Rotation Sensor Test

To enable the "Advanced Menu" set up the "Access code" (1234) using the

, DOWN

, RIGHT

keys.

Press

- "Menu advanced" appears on the display

UP LOAD FIRMWARE

Allows you to transfer the firmware from 1 fixture to all the connected fixtures.

1) Press

, a confirmation message appears on the display.

2) Select YES to start the firmware loading or NO to keep the current set-

ting and return to the top menu level

SETUP MODEL

Allows you to change the default model of projector.

1) Press

a confirmation message appears on the display.

2) Select YES to define the model of projector or NO to keep the current

setting and return to the top menu level.

CALIBRATION

Allows you to adjust effects from the control panel to obtain perfect unifor-

mity between the projectors.

1) Press

- “channels” appears on the display.

2) Using the UP

and DOWN

keys, select the effect you wish to

regulate.

3) Press

and use the RIGHT

, UP

and DOWN

buttons to

make the adjustment by setting a value between 0 and 255.

4) Press

to confirm the selection

LEFT

to keep current set-

tings and return to the top level.

FACTORY DEFAULT

Allows you to restore default values of all channels (128).

1) Press

– a confirmation message appears on the display (Reset

calibration to factory default ?).

2) Select YES to reset calibration to factory default or NO to keep the

current setting and return to the top menu level.

anual

ontrol

Yes

Reset

hannel

est

an-Tilt

Colour

oom

Rotation

All

oom Rot Sens Test

Advanced

Code

1234

Calibration

Upload

Aleda fw

Transfer the firmware on all

the connected fixtures ?

Are you sure ?

Yes/No

Setup

Model

Changing to a wrong model

may damage the fixture.

Are you sure ?

Yes/No

MANUAL CONTROL

TEST MENU

ADVANCED MENU

etwork

arams

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Clay-paky A.LEDA B-EYE K20 (C61420) User Manual Page 15

Comments to this Manuals

Related products and manuals for Lighting Clay-paky A.LEDA B-EYE K20 (C61420)